Electro-Hydraulic scissor lift, with capacity of 2500 KG and a lifting height of 1 meter
The lift suits ideally to works such as wheel, tyre, brake and suspension services, thanks to its lifting height from the category of 1 meter. It’s also adapted to body shop works.
Technical specification:
Capacity:
2500 Kg
Lifting time:
12 sec.
Lowering time:
12 sec.
Power supply:
400V - 3 ph - 50 HZ + PE + Neutral
Motor:
1.8 KW
Hydraulic pressure :
230 bar
Net weight:
400 kg
Packed weight:
420 kg
The GALAXIE scissor lifts are available with or without auxiliary lift table, and offer very modern features as a synthesis of the great experience of FOG, to strengthen your productivity.
A range of scissor lifts, entirely new, to meet the exact demands of professionals and characterized by the following common advantages:
Runways length 4,600 mm (or 5,200 mm for the so-called roadworthiness test versions).
Capacity 4,200 kg
Maximum lifting height of 2100 mm, for tall people.
Thickness from the floor: 350 mm
Ultra compact control terminal, with drawing similar to the one on the “Satellite”.
Control keyboard with LEDs for diagnosis.
Bases as a standard for optional lifting arm 4205500A (all models).
Axes of main lift provided with lubricators.
Made in France.
Safety:
Certified CE and EN1493 by Bureau Veritas.
New:
The runways length may be extended up to 4,900 mm or 5,200 mm with optional consoles (also CE and EN1493 certified) on all the models.
Integrated auxiliary lift (on the versions equipped):
Capacity of auxiliary lift 3,500 kg
Lifting tables with adjustable length (standard on all models)
Lifting height 480 mm.
Versions for wheel alignment:
Front recesses for flush-mounted turntables.
Fully integrated rear side slip (locking by pin).
Versions for roadworthiness test and inspection:
Top-of-the-range pneumatic play plates to check the front axles, with a control torch lamp.
Fast up and down motions (respectively 35s and 30s), with 5 kW motor
Surface- or recessed-mounted configuration, as requested
WHEEL FREE LOW PROFILE, DOUBLE SCISSOR LIFT
New model of double scissor lift, extra flat, with hold beneath the body, meant for garages or inspection centres.
Main characteristics:
Nominal capacity 3,000 kg
Lifting height 2,010 mm
Height from the floor: 117 mm
Lifting tables with length adjustable from 1,500 to 2,020 mm.
The Satellite range provides a decisive development:
Unequalled lifting capacity from the floor of 2,000 kg (obtained by means of a specific cam).
The nominal lifting capacity of 3,000 kg is reached just after the first few lifting centimetres.
Lifting of low vehicles, vehicles with hydraulic suspension out of order, or vehicles without wheels.
Total safety:
CE and EN1493 certificate delivered by Bureau Veritas.
Mechanical safety devices.
Checking device with photo-electric cell.
Reinforced structure:
Use of special steels with high elasticity limit.
Reversible loading.
Resistance to the constraints imposed by the capacity of 2,000 kg in low position.
New optimised design of the lifting ramps.
A design which takes into consideration the configuration of the garages:
The control terminal may be located either on the left or on the right hand side of the structure.
Available as a version put directly on the floor (short or long drive-on ramps), and as recessed versions, with terminal, or with wall-mounted box.
Numerous advantages in use:
Fast, smooth up and down motions.
Damped start to protect the lower part of the body.
Typical “Fog” control keyboard, very simple and therefore reliable.
Ultra-compact control terminal.
Front and rear extensions controlled with foot pedal.
Free access under the vehicle, without any linking bar.
